Driver Installation Procedures
	
Microsoft Windows 2000 and Windows Server 2003

After Operating System Installation

	NOTE:  For a first-time driver installation, the plug-and-play (PNP) Found New 
	Hardware wizard is displayed by the Device Manager. Click Cancel.

To install the driver after installing the operating system:
1.	Extract the contents of aac4.2.0.7344.zip to a local directory or floppy drive.
2.	Open Device Manager, SCSI Controllers
3.	Right click on the Adaptec 2610SA Controller and select properties
4.	Select the driver tab, and click on the Driver Update button
5.	Check the floppy option, then click on the OK button
6.	Proceed with the installation wizard, followed by rebooting the system

During Operating System Installation 

To install the driver during the operating system installation:
1.	Follow the operating system instructions to start the Microsoft Windows 2000 
	and Windows Server 2003 installation.
2.	When prompted, press the F6 key.  

	IMPORTANT:  If the F6 key is not pressed during the brief interval when the 
	prompt is displayed, the installation must be restarted.

		A blue screen is displayed with the following message:
			S=Specify Additional Device 
			ENTER=Continue
			F3=Exit

3.	Press the S key. If a menu is displayed, use the arrow keys to scroll to Other and 
	press the Enter key.
4.	When prompted to insert the manufacturer-supplied diskette, insert the Windows 2000 
	or Window Server 2003 driver diskette and press the Enter key.

	NOTE:  To create a driver diskette Extract the contents of aac4.2.0.7344.zip to a 
	floppy drive.

5.	Select the "Adaptec SATA Controller" and press the Enter key. The screen for 
	specifying additional drivers is displayed again. If you do not have any additional 
	drivers to install, press the Enter key.
6.	Follow the on-screen instructions to complete the installation.

	IMPORTANT:  Do not remove the diskette from the drive until instructed to do so.
 
7.	Reboot the server.

	NOTE:  The following steps install the Event Notification driver.

8.	Extract the "Setup.exe" file from evtdaemon8.00.06.zip to a local directory.
9.	From the local directory run Setup.exe and follow the on screen prompts. 
10.	Reboot the system after the installation completes.



 
  

 
