RASCAL 2.1

  RASCAL is a program for interactive design of reflector antennas.

  System Requirements:
    80286 or higher, with math coprocessor.
    MS-DOS 5.0 or higher.
    Mouse with installed driver.

  The disk contains the files:
    README.TXT 
    RASEXE.EXE
    RASSOR.EXE
    INSTALL.BAT

  Installation:    
    Copy "RASEXE.EXE" to your hard drive in the directory where 
    you want RASCAL to reside. Type in "RASEXE" and hit return. 
    The RASCAL executable files will self-extract. Type "RASCAL" 
    to run the software. Repeat the above procedure with 
    "RASSOR.EXE" for the source files, if desired.

  File List:
    Executable files:
      RASCAL.BAT
      EGAVGA.BGI
      RAS1.EXE
      RAS2.EXE
      RAS3.EXE
      RAS4.EXE
      CREDIT.EXE
      MENU.EXE
      TITLE.EXE
      END.EXE
    Source files: 
      ANTFUNCS.H
      MATHPROC.H
      GLOBALS.H
      CONSTS.H
      MATHERR.C
      GRINPUT.C
      MOUSE.C
      PLOT1.C
      MATHPROC.C
      PLOT2.C
      WINS.C
      PLOT3.C
      ANTENNA1.C
      PATTERN.C
      INIT1.C
      CTRL1.C
      CONTROL2.C
      INIT4.C
      CONTROL1.C
      MENU.C
      CTRL3.C
      ANTENNA2.C
      CONTROL3.C
      CONTROL4.C 
      ANTENNA3.C
      ANTENNA4.C
      CREDIT.C
      PLOT4.C
      ANT.C
      CTRL2.C
      CTRL4.C
      SAVEIMG.C
      INIT2.C
      INIT3.C
      RAS1.PRJ
      RAS2.PRJ
      RAS3.PRJ
      RAS4.PRJ

  Comments:
    1. RASCAL can be run either from RASCAL.BAT or from its four different
       executable files.  When running directly from the executables, the
       older data files will NOT be deleted.
    2. Historical reasons present during RASCAL's development caused a 
       non-correspondence between the menu and executable file numbers.
       We apologize for any possible confusion that this may cause.

  Copyright Notice:
    RASCAL is FREE and must be distributed with all its files intact.

Authors:
        Yung-hsiang Lee
        Kenneth W. Brown
        Aluizio Prata, Jr.


